Activating Guard1 Plus SE

Published: 2006-09-13

 

Last Updated: 2010-07-26

Applies To

Introduction

After installing Guard1 Plus SE Server and configuring your databases, you must activate the software to apply the licenses you've purchased.

 

Refer to the Guard1 Plus SE Administrator's Manual for complete information on the installation process.  The manual can also be found in PDF format on your Guard1 Plus SE Server CD.

 

To activate Guard1 Plus SE:

NOTE: Internet access is required at the PC where you run the Activate Software Wizard.

 

  1. From a workstation that has a Guard1 Plus SE Local Client installed, browse to the shared Guard1 Plus SE Server folder on the file server, i.e. \\server name\share name.
  2. Double-click the G1ActivateSoftware.exe file to start the Activate Software Wizard.
  3. The only available radio button should be Obtain an Authorization license.
  4. Click Next.
  5. Enter your Support Code and Password. Your Support Code and Password are included with your Guard1 Plus SE shipment. If you can not find this information, contact Technical Support by phone or email.
  6. Click Next.
  7. Enter your contact information including your email address. Your email address is particularly important as your license file will be sent to this address. Please note that all data fields are required except Fax.
    • TimeKeeping Systems, Inc. respects your privacy and we will never provide any of your contact information to third parties.
  8. Click Next.
  9. Review the information that was entered. Click Back to correct any of the data or click Next to continue.
  10. Click Next to send your activation information to our server.
  11. Click Finish to exit from the Activate Software Wizard.
  12. You will receive your license file by email in a few minutes but no more than an hour. If an hour has passed and you still do not have the email containing your license file, contact Technical Support for assistance.
  13. Once you have received your license file, save it to a convenient folder, then browse to the shared Guard1 Plus SE Server folder on the file server, i.e. \\server name\share name.
  14. Double-click the G1ActivateSoftware.exe file to start the Activate Software Wizard again.
  15. The only available radio button should be I'm ready to complete the process. I have an authorization license.
  16. Click Next.
  17. Click Browse to locate and select your license file.
  18. Click Next.
  19. The next screen should give you a message that Guard1 Plus SE has been activated successfully.
  20. Click Finish to exit from the Activate Software Wizard.

 

Your software is now activated, and you can now open and log in to your workstation applications.

 

 

 

 

 

 

 

 

 

 

 

 

 

Copyright © 2013 TimeKeeping Systems, Inc.